Reference Guide

-------------------------------------------------------------
4| 0| IPv4Flow| 232| 0|
Allowed
4| 0| IPv6Flow| 0| 0|
Allowed
Dell#
Dell#test cam-usage service-policy input LauraMapTest linecard
2 port-set 1
Linecard|Portpipe| CAM Partition|Available CAM|Estimated CAM
per Port|Status
---------------------------------------------------------------
--
2| 1| IPv4Flow| 232| 0|
Allowed
2| 1| IPv6Flow| 0| 0|
Allowed
Dell#
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
match ipv6 address
Configure a filter to match routes based on IPv6 addresses specified in an access list.
C-Series, E-Series, S-Series
Syntax
match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name
command.
Parameters
prefix-list-
name
Enter the name of IPv6 prefix list, up to 140 characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, the
names are up to 16 characters long.
IPv6 Access Control Lists (IPv6 ACLs)
1011