Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with
the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute the
duplex command.
Related
Commands
● negotiation auto — enable or disables auto-negotiation on an interface.
duplex (Management interface)
Configure duplex mode on a management interface whose speed is set to 10/100 Mb/s.
S5000
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only in one
direction.
full Enter the keyword full to set the physical interface to transmit in both
directions.
Defaults Not configured.
Command Modes INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies only to management interfaces with speed set to 10/100 Mb/s using the speed
command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the duplex command.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the primary or
standby stack-unit).
eee
Enable Energy-Efficient Ethernet (EEE) on native or optional module copper ports.
Syntax
eee
To disable EEE, use the no eee command.
Defaults None.
Command Modes INTERFACE
628 Interfaces