Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell #clear dampening tegigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
Dell#
Related
Commands
● show interfaces dampening — display interface dampening information.
● dampening — configure dampening on an interface.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used at the selected port:
● short = For 1-meter and 3-meter cable lengths.
● medium = For 5-meter cable length.
● long = For 10-meter and 15-meter cable lengths.
Defaults medium
Command Modes INTERFACE
Command
History
Version Description
7.7.1.0 Introduced on the S-Series.
Usage
Information
This command only works on ports that the system recognizes as CX4 ports. The show interfaces
command shown in the Example below describes an attempt to configure an XFP port in an S25P with
the command after inserting a CX4 converter into the port.
NOTE: When using a long CX4 cable between the C-Series and the S-Series, to avoid errors,
configure the cable using the cx4-cable-length short command only.
NOTE: The 15M CX4 active cable is not supported on the C-Series and S-series. It is only supported
for S2410 with active end on the device.
Interfaces 623