Reference Guide

- - - network rw ftp:

- - - network rw tftp:

- - - network rw scp:

You can change the default file system so that file management commands apply to a particular device

or memory.

To change the default directory, use the following command.

• Change the default directory.

EXEC Privilege mode

cd directory

You can change the default storage location to the USB Flash. File management commands then apply to

the USB Flash rather than the internal Flash.

Dell#cd usbflash:

Dell#

copy running-config test

3998 bytes successfully copied

Dell#dir

Directory of usbflash:

1 drwx 4096 Jan 01 1980 00:00:00 +00:00 .

2 drwx 2048 May 02 2012 07:05:06 +00:00 ..

3 -rwx 1272 Apr 29 2011 16:15:14 +00:00 startup-config

4 -rwx 3998 May 11 2011 23:36:12 +00:00 test

Enabling Software Features on Devices Using a Command

Option

This capability to activate software applications or components on a device using a command is

supported on the S4810, S4820T, and S6000, platforms.

Starting with Release 9.4(0.0), you can enable or disable specific software functionalities or applications

that need to run on a device by using a command attribute in the CLI interface. This capability enables

effective, streamlined management and administration of applications and utilities that run on a device.

You can employ this capability to perform an on-demand activation or turn-off of a software component

or protocol. A feature configuration file that is generated for each image contains feature names denotes

whether this enabling or disabling method is available for such features. In 9.4(0.0), you can enable or

disable the VRF application globally across the system by using this capability.

You can activate VRF application on a device by using the feature vrf command in CONFIGURATION

mode.

NOTE: The no feature vrf command is not supported on any of the platforms.

To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI

interface, use the following command. You must enable the VRF feature before you can configure its

related attributes.

Dell(conf)# feature vrf

Getting Started