Reference Guide

Showing an IPv6 Interface
To view the IPv6 configuration for a specific interface, use the following command.
• Show the currently running configuration for the specified interface.
EXEC mode
show ipv6 interface type {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
– For all brief summary of IPv6 status and configuration, enter the keyword brief.
– For all IPv6 configured interfaces, enter the keyword configured.
– For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/ port
information.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then the Loopback number.
– For a port-channel interface, enter the keywords port-channel then the port-channel number.
– For a VLAN interface, enter the keyword vlan then the VLAN ID.
Example of the show ipv6 interface Command
Dell#show ipv6 interface te 2/2
TenGigabitEthernet 2/2 is down, line protocol is down
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe06:95a3
Global Unicast address(es):
3:4:5:6::8, subnet is 3::/24
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:8
ff02::1:ff06:95a3
MTU is 1500
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 1
ND reachable time is 30 seconds
ND advertised reachable time is 30 seconds
ND advertised retransmit interval is 30 seconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
Showing IPv6 Routes
To view the global IPv6 routing information, use the following command.
• Show IPv6 routing information for the specified route type.
EXEC mode
show ipv6 route type
The following keywords are available:
IPv6 Routing
499