Reference Guide

CONFIGURATION mode or VLAN INTERFACE mode
fip-snooping fc-map fc-map-value
The valid values are from 0EFC00 to 0EFCFF.
The default is 0x0EFC00.
4. Configure the maximum number of FIP-snooping sessions supported on the switch for an ENode
MAC address.
CONFIGURATION mode
fip-snooping max-sessions-per-enodemac max-value
Valid values are from 1 to 64.
The default is 32 sessions are supported.
5. Enter the interface configuration level to configure a 10-Gigabit Ethernet or FC port for FIP snooping.
CONFIGURATION mode
interface port-type slot/port
NOTE: By default, a port is enabled for bridge-to-ENode links.
6. Configure the port for bridge-to-FCF links.
INTERFACE mode or CONFIGURATION mode
fip-snooping port-mode fcf
To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a command; for
example, no feature fip-snooping or no fip-snooping enable.
Displaying FIP Snooping Information
To display information on FIP snooping, use the following show commands.
Table 22. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface
vlan vlan-id]
Displays information on FIP-snooped sessions on
all VLANs or a specified VLAN, including the ENode
interface and MAC address, the FCF interface and
MAC address, VLAN ID, FCoE MAC address and
FCoE session ID number (FC-ID), worldwide node
name (WWNN) and the worldwide port name
(WWPN).
show fip-snooping config
Displays the FIP snooping status and configured
FC-MAP values.
show fip-snooping enode [enode-mac-
address]
Displays information on the ENodes in FIP-
snooped sessions, including the ENode interface
and MAC address, FCF MAC address, VLAN ID and
FC-ID.
show fip-snooping fcf [
fcf-mac-address]
Displays information on the FCFs in FIP-snooped
sessions, including the FCF interface and MAC
FCoE Transit
361