Reference Guide

NOTE: ACL resequencing does not affect the rules, remarks, or order in which they are applied.
Resequencing merely renumbers the rules so that you can place new rules within the list as needed.
Table 7. ACL Resequencing
Rules Resquencing
Rules Before Resequencing: seq 5 permit any host 1.1.1.1
seq 6 permit any host 1.1.1.2
seq 7 permit any host 1.1.1.3
seq 10 permit any host 1.1.1.4
Rules After Resequencing: seq 5 permit any host 1.1.1.1
seq 10 permit any host 1.1.1.2
seq 15 permit any host 1.1.1.3
seq 20 permit any host 1.1.1.4
Resequencing an ACL or Prefix List
Resequencing is available for IPv4 and IPv6 ACLs, prefix lists, and MAC ACLs.
To resequence an ACL or prefix list, use the following commands. You must specify the list name, starting
number, and increment when using these commands.
• IPv4, IPv6, or MAC ACL
EXEC mode
resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum
Step-to-Increment}
• IPv4 or IPv6 prefix-list
EXEC mode
resequence prefix-list {ipv4 | ipv6} {prefix-list-name StartingSeqNum Step-
to-Increment}
Example of Resequencing ACLs When Remarks and Rules Have the Same Number
Example of Resequencing ACLs When Remarks and Rules Have Different Numbers
The example shows the resequencing of an IPv4 access-list beginning with the number 2 and
incrementing by 2.
Remarks and rules that originally have the same sequence number, have the same sequence number
after you apply the resequence command.
Dell(config-ext-nacl)# show config
!
ip access-list extended test
remark
4 XYZ
remark 5 this remark corresponds to permit any host 1.1.1.1
seq
5 permit ip any host 1.1.1.1
remark 9 ABC
remark
10 this remark corresponds to permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.2
seq 15 permit ip any host 1.1.1.3
144
Access Control Lists (ACLs)