Reference Guide

1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
-- Module Info --
Unit Module No Status Module Type Ports
-------------------------------------------------------
0 0 online S5000-MOD-12XETH10-F 12
0 1 not present No Module 0
0 2 online S5000-MOD-12XETH10-F 12
0 3 not present No Module 0
-- Power Supplies --
Unit Bay Status Type FanStatus
-------------------------------------------------------
0 0 up DC up
0 1 up DC up
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed Fan2 Speed Fan3 Speed
---------------------------------------------------------------
0 0 absent or down
0 1 up up 4800 up 4800 up 4800 up 4800
0 2 up up 4800 up 4800 up 4800 up 4800
0 3 absent or down
Dell#
As shown in the following two examples, log messages differ somewhat when diagnostics are done on a
standalone unit and on a stack member.
The following is an example of running offline diagnostics on a standalone unit.
Dell#diag stack-unit 1 alllevels
Warning - diagnostic execution will cause multiple link flaps on the peer side
- advisable
to shut directly connected ports
Proceed with Diags [confirm yes/no]: yes
00:03:35: %S5000:1 %DIAGAGT-6-DA_DIAG_STARTED: Starting diags on stack unit 1
00:03:35 : Approximate time to complete these Diags ... 6 Min
Dell#00:09:32 : Diagnostic test results are stored on file: flash:/TestReport-
SU-0.txt
00:09:37: %S5000:0 %DIAGAGT-6-DA_DIAG_DONE: Diags finished on stack unit 0
Diags completed... Rebooting the system now!!!
[reboot output omitted]
Dell#00:01:35: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console by
console
dir
Directory of flash:
1 drw- 16384 Jan 01 1980 00:00:00 +00:00 .
S5000 Debugging and Diagnostics
1063