Users Guide

Configuring FTP Client Parameters
To configure FTP client parameters, use the following commands.
• Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the GigabitEthernet keyword then the slot/port
information.
• For a loopback interface, enter the loopback keyword then a number between 0 and 16383.
• For a port channel interface, enter the port-channel keyword then a number from 1 to 255 for
TeraScale and ExaScale.
• For a 10-Gigabit Ethernet interface, enter the TenGigabitEthernet keyword then the slot/port
information.
• For a VLAN interface, enter the vlan keyword then a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the fortyGigE keyword then the slot/port information.
CONFIGURATION mode
ip ftp source-interface interface
• Configure a password.
CONFIGURATION mode
ip ftp password password
• Enter a username to use on the FTP client.
CONFIGURATION mode
ip ftp username name
To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode, as
shown in the example for
Enabling the FTP Server.
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles.
Terminal lines on the system provide different means of accessing the system. The console line (console)
connects you through the console port in the route processor modules (RPMs). The virtual terminal lines
(VTYs) connect you through a remote session to the system. The auxiliary line (aux) connects secondary
devices such as modems.
Switch Management 92