Users Guide

• limit: the range is from 20 to 300. The default is 20.
To view the logging synchronous configuration, use the show config command in LINE mode.
Enabling Timestamp on Syslog
Messages
By default, syslog messages do not include a time/date stamp stating when the error or message was created.
To enable timestamp, use the following command.
• Add timestamp to syslog messages.
CONFIGURATION mode
service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone] |
uptime]
Specify the following optional parameters:
• You can add the localtime keyword to include the localtime, msec, and show-timezone. If you
do not add the
localtime keyword, the time is UTC.
• uptime: To view time since last boot.
If you do not specify a parameter, Dell Networking OS configures uptime.
To view the configuration, use the show running-config logging command in EXEC privilege mode.
To disable time stamping on syslog messages, use the no service timestamps [log | debug]
command.
File Transfer Services
With Dell Networking OS, you can configure the system to transfer files over the network using the file
transfer protocol (FTP).
One FTP application is copying the system image files over an interface on to the system; however, FTP is not
supported on virtual local area network (VLAN) interfaces.
For more information about FTP, refer to RFC 959, File Transfer Protocol.
NOTE
: To transmit large files, Dell Networking recommends configuring the switch as an FTP server.
Configuration Task List for File Transfer
Services
The configuration tasks for file transfer services are:
Switch Management 90