Users Guide

Field Description
• Active (all mandatory FCoE and FC parameters are correctly configured)
• Incomplete (either the FC-MAP value, fabric ID, or VLAN ID are not correctly
configured)
Oper-State Operational status of link to the fabric:
• up (link is up and transmitting FC traffic)
• down (link is down and not transmitting FC traffic),
• link-wait (link is up and waiting for FLOGI to complete on peer FC port)
• removed (port has been shut down)
Members Ethernet and FC ports that are members of the dedicated FCoE VLAN that carries
storage traffic to the specified fabric.
Example of the show qos-dcb-map Command
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
The following lists the show qos dcb-map command example field descriptions.
Term heading Description heading
State
• Complete: All mandatory DCB parameters are correctly configured.
• In progress: The DCB map configuration is not complete. Some mandatory
parameters are not configured.
PFC Mode PFC configuration in the DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used in the DCB map: Enhanced Transmission
Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
Dell# show npiv devices brief
Total NPIV Devices = 2
----------------------------------------------------------------------------------
ENode-Intf ENode-WWPN FCoE-Vlan Fabric-Intf Fabric-Map LoginMethod Status
-----------------------------------------------------------------------------------
Te 0/12 20:01:00:10:18:f1:94:20 1003 Fc 0/5 fid_1003 FLOGI LOGGED_IN
Te 0/13 10:00:00:00:c9:d9:9c:cb 1003 Fc 0/0 fid_1003 FDISC LOGGED_IN
NPIV Proxy Gateway 715