Users Guide

!
15 bytes successfully copied
Dell#copy flash://ashu/capture.txt.pcap nfsmount:///
Destination file name [test.txt]:
!
15 bytes successfully copied
Dell#copy flash://ashu/capture.txt.pcap nfsmount:///ashutosh/snoop.pcap
!
24 bytes successfully copied
Dell#
Dell#copy tftp://10.16.127.35/mashutosh/dv-maa-test ?
flash: Copy to local file system ([flash://]filepath)
nfsmount: Copy to nfs mount file system (nfsmount:///filepath)
running-config remote host:
Destination file name [test.c]:
!
225 bytes successfully copied
Dell#
Saving the Running-Configuration
The running-configuration contains the current system configuration. Dell Networking recommends coping
your running-configuration to the startup-configuration.
The system uses the startup-configuration during boot-up to configure the system. The startup-configuration
is stored in the internal flash on the IOM by default, but you can save the startup-configuration to a USB flash
device or on a remote server.
NOTE
: The commands in this section follow the same format as those in
Copying Files to and from the System but use the filenames startup-configuration and running-
configuration. These commands assume that current directory is the internal flash, which is the system
default.
• Save the running-configuration to the startup-configuration on the internal flash.
EXEC Privilege mode
copy running-config startup-config
• Save the running-configuration to the usb flash on the IOM.
EXEC Privilege mode
copy running-config usbflash://filename
• Save the running-configuration to an FTP server.
EXEC Privilege mode
copy running-config ftp:// username:password@{hostip | hostname}/filepath/
filename
• Save the running-configuration to a TFTP server.
EXEC Privilege mode
copy running-config tftp://{hostip | hostname}/filepath/ filename
• Save the running-configuration to an SCP server.
EXEC Privilege mode
Getting Started 65