Users Guide

6 (Optional) Configures the advertised priority bitmap in iSCSI application TLVs.
CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
7 (Optional) Enter interface configuration mode to configure the auto-detection of Dell Compellent disk
arrays.
CONFIGURATION mode
interface port-type slot/port
8 (Optional) Configures the auto-detection of Dell Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Dell Compellent disk arrays are not detected.
Displaying iSCSI Optimization
Information
To display information on iSCSI optimization, use the following show commands.
• Display the currently configured iSCSI settings.
show iscsi
• Display information on active iSCSI sessions on the switch.
show iscsi sessions
• Display detailed information on active iSCSI sessions on the switch. To display detailed information on
specified iSCSI session, enter the session’s iSCSI ID.
show iscsi sessions detailed [session isid]
• Display all globally configured non-default iSCSI settings in the current Dell Networking OS session.
show run iscsi
Examples of the show iscsi Commands
The following example shows the show iscsi command.
Dell#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
iSCSI Optimization 566