Users Guide

NOTE: Because different networking vendors define MTU differently, check their documentation when
planning MTU sizes across a network.
The following table lists the range for each transmission media.
Transmission
Media
MTU Range (in bytes)
Ethernet
594-12000 = link MTU
576-9234 = IP MTU
Link Bundle Monitoring
Monitoring linked LAG bundles allows traffic distribution amounts in a link to be monitored for unfair
distribution at any given time. A threshold of 60% is defined as an acceptable amount of traffic on a member
link. Links are monitored in 15-second intervals for three consecutive instances. Any deviation within that time
sends Syslog and an alarm event generates. When the deviation clears, another Syslog sends and a clear
alarm event generates.
The link bundle utilization is calculated as the total bandwidth of all links divided by the total bytes-per-
second of all links. If you enable monitoring, the utilization calculation is performed when the utilization of
the link-bundle (not a link within a bundle) exceeds 60%.
To enable and view link bundle monitoring, use the following commands.
• Enable link bundle monitoring.
ecmp-group
• View all LAG link bundles being monitored.
show running-config ecmp-group
• Enable link bundle monitoring on port channel interfaces.
link-bundle-monitor enable
Dell(conf-if-po-10)#link-bundle-monitor enable
• Configure threshold level for link bundle monitoring.
link-bundle-distribution trigger-threshold
Dell(conf)#link-bundle-distribution trigger-threshold
• View the link bundle monitoring status.
show link-bundle-distribution
Interfaces 507