Users Guide

IP ACCESS-LIST
STANDARD ACCESS-LIST
EXTENDED ACCESS-LIST
LINE
CONSOLE
VIRTUAL TERMINAL
MAC ACCESS-LIST
MAC CONTROL-PLANE
MONITOR SESSION
MULTIPLE SPANNING TREE
Per-VLAN SPANNING TREE
RAPID SPANNING TREE
GVRP
LLDP
FIBRE CHANNEL
PREFIX-LIST
REDIRECT
ROUTE-MAP
ROUTER BGP
ROUTER ISIS
ROUTER OSPF
ROUTER RIP
SPANNING TREE
TRACE-LIST
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI
mode. Move linearly through the command modes, except for the end command which takes you directly to
EXEC Privilege mode and the exit command which moves you up one command mode level.
NOTE: Sub-CONFIGURATION modes all have the letters “conf” in the prompt with more modifiers to
identify the mode and slot/port information.
Table 1. Dell Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC
Dell>
Access the router through the
console or Telnet.
EXEC Privilege
Dell#
• From EXEC mode, enter the
enable command.
• From any other mode, use
the end command.
CONFIGURATION
Dell(conf)#
• From EXEC privilege mode,
enter the configure
command.
• From every mode except
EXEC and EXEC Privilege,
enter the exit command.
Configuration Fundamentals 42