Users Guide

CONFIGURATION mode or VLAN INTERFACE mode
fip-snooping enable
The default for FIP snooping is disabled on all VLANs.
3 Configure the FC-MAP value FIP snooping uses to identify an ENode MAC address on all VLANs.
CONFIGURATION mode or VLAN INTERFACE mode
fip-snooping fc-map fc-map-value
The valid values are from 0EFC00 to 0EFCFF.
The default is 0x0EFC00.
4 Configure the maximum number of FIP-snooping sessions supported on the switch for an ENode MAC
address.
CONFIGURATION mode
fip-snooping max-sessions-per-enodemac max-value
Valid values are from 1 to 64.
The default is 32 sessions are supported.
5 Enter the interface configuration level to configure a 10-Gigabit Ethernet or FC port for FIP snooping.
CONFIGURATION mode
interface port-type slot/port
NOTE: By default, a port is enabled for bridge-to-ENode links.
6 Configure the port for bridge-to-FCF links.
INTERFACE mode or CONFIGURATION mode
fip-snooping port-mode fcf
To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a command; for example,
no feature fip-snooping or no fip-snooping enable.
Displaying FIP Snooping Information
To display information on FIP snooping, use the following show commands.
Table 29. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface
vlan vlan-id]
Displays information on FIP-snooped sessions on all
VLANs or a specified VLAN, including the ENode
interface and MAC address, the FCF interface and
MAC address, VLAN ID, FCoE MAC address and FCoE
FCoE Transit 401