Users Guide

To create a QoS output policy that allocates different amounts of bandwidth to the different traffic types/
dot1p priorities assigned to a queue and apply the output policy to the interface, follow these steps.
1 Create a QoS output policy.
CONFIGURATION mode
Dell(conf)#qos-policy-output test12
The maximum 32 alphanumeric characters.
2 Configure the percentage of bandwidth to allocate to the dot1p priority/queue traffic in the associated
L2 class map.
QoS OUTPUT POLICY mode
Dell(conf-qos-policy-out)#bandwidth-percentage 100
The default is none.
3 Repeat Step 2 to configure bandwidth percentages for other priority queues on the port.
QoS OUTPUT POLICY mode
Dell(conf-qos-policy-out)#bandwidth-percentage 100
4 Exit QoS Output Policy Configuration mode.
QoS OUTPUT POLICY mode
Dell(conf-if-te-0/1)#exit
5 Enter INTERFACE Configuration mode.
CONFIGURATION mode
interface type slot/port
6 Apply the QoS output policy with the bandwidth percentage for specified priority queues to an egress
interface.
INTERFACE mode
Dell(conf-if-te-0/1)#service-policy output test12
Configuring ETS in a DCB Map
A switch supports the use of a DCB map in which you configure enhanced transmission selection (ETS)
setting. To configure ETS parameters, you must apply a DCB map on an interface.
ETS Configuration Notes
ETS provides a way to optimize bandwidth allocation to outbound 802.1p classes of converged Ethernet
traffic. Different traffic types have different service needs. Using ETS, you can create groups within an 802.1p
priority class to configure different treatment for traffics with different bandwidth, latency, and best-effort
needs.
Data Center Bridging (DCB) 321