Users Guide

Configuring dot1x Profile
You can configure a dot1x profile for defining a list of trusted supplicant MAC addresses. A maximum of 10
dot1x profiles can be configured. The profile name length is limited to 32 characters. Thedot1x profile
{profile-name} command sets the dot1x profile mode and you can enter profile-related commands, such
as the mac command.
To configure a dot1x profile, use the following commands.
• Configure a dot1x profile.
CONFIGURATION mode
dot1x profile {profile-name}
profile—name — Enter the dot1x profile name. The profile name length is limited to 32 characters.
Example of Configuring and Displaying a dot1x Profile
Dell(conf)#dot1x profile test
Dell(conf-dot1x-profile)#
Dell#show dot1x profile
802.1x profile information
-----------------------------
Dot1x Profile test
Profile MACs
00:00:00:00:01:11
Configuring the Static MAB and MAB
Profile
Enable MAB (mac-auth-bypass) before using the dot1x static-mab command to enable static mab.
To enable static MAB and configure a static MAB profile, use the following commands.
• Configure static MAB and static MAB profile on dot1x interface.
INTERFACE mode
dot1x static-mab profile profile-name
Eenter a name to configure the static MAB profile name. The profile name length is limited to a maximum
of 32 characters.
Example of Static MAB and MAB Profile for an Interface
Dell(conf-if-Te-2/1)#dot1x static-mab profile sample
Dell(conf-if-Te 2/1))#show config
!
interface TenGigabitEthernet 21
switchport
dot1x static-mab profile sample
no shutdown
802.1X 132