Users Guide

Dell(conf-if-vlan)#tagged po 1
Dell(conf-if-vlan)#show conf
!
interface Vlan 4
no ip address
tagged Port-channel 1
Dell(conf-if-vlan)#end
Dell#
show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active T Po1(So 0/0-1)
T Te 3/0
3 Active T Po1(So 0/0-1)
T Te 3/1
4 Active T Po1(So 0/0-1)
Dell#
When you remove a tagged interface from a VLAN (using the no tagged interface command), it remains
tagged only if it is a tagged interface in another VLAN. If the tagged interface is removed from the only VLAN
to which it belongs, the interface is placed in the Default VLAN as an untagged interface.
Moving Untagged Interfaces
To move untagged interfaces from the Default VLAN to another VLAN, use the following commands.
1 Access INTERFACE VLAN mode of the VLAN to which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
2 Configure an interface as untagged.
INTERFACE mode
untagged interface
This command is available only in VLAN interfaces.
Move an Untagged Interface to Another VLAN
The no untagged interface command removes the untagged interface from a port-based VLAN and
places the interface in the Default VLAN. You cannot use the
no untagged interface command in the
Default VLAN. The following example shows the steps and commands to move an untagged interface from
the Default VLAN to another VLAN.
The only way to remove an interface from the Default VLAN is to place the interface in Default mode by
entering the no switchport command in INTERFACE mode.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
Virtual LANs (VLANs) 1114