Reference Guide

mib-binding
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
S5000
Syntax
mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command
Modes
ROUTER OSPF
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the
MIB manager, the first OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new
process ID the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S5000
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-
id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid
IP address. Decimal value range is 0 to 65535. IP address
format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Open Shortest Path First (OSPFv2)
995