Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
All neighboring routers in the same network must use the same password to
exchange OSPF information.
ip ospf cost
Change the cost associated with the OSPF traffic on an interface.
S5000
Syntax
ip ospf cost cost
To return to default value, use the no ip ospf cost command.
Parameters
cost Enter a number as the cost. The range is 1 to 65535.
Defaults The default cost is based on the reference bandwidth.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If this command is not configured, cost is based on the auto-cost command.
When you configure OSPF over multiple vendors, use the ip ospf cost
command to ensure that all routers use the same cost. Otherwise, OSPF routes
improperly.
Related
Commands
auto-cost – controls how the OSPF interface cost is calculated.
ip ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the interval elapses, the
neighboring routers declare the router dead.
S5000
Syntax
ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Open Shortest Path First (OSPFv2)
989