Reference Guide

distribute-list in
Apply a filter to incoming routing updates from OSPF to the routing table.
S5000
Syntax
distribute-list prefix-list-name in [interface-type slot/port]
To delete a filter, use the no distribute-list prefix-list-name in
[interface-type slot/port] command.
Parameters
prefix-list-
name in
Enter the name of a configured prefix list followed by the
keyword in.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults Not configured.
Command
Modes
ROUTER OSPF
Command
History
Version 9.0(1.3) Introduced on the S5000.
distribute-list out
Apply a filter to restrict certain routes destined for the local routing table after the SPF calculation.
S5000
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
static]
To remove a filter, use the no distribute-list prefix-list-name out
[bgp | connected | isis | static] command.
Open Shortest Path First (OSPFv2)
983