Reference Guide

LoginMethod : FDISC
Secs : 5593
Status : LOGGED_IN
Related
Commands
dcb-map — creates a DCB map to configure DCB parameters on Ethernet ports
that support converged Ethernet traffic.
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fc switch
Display the switch configuration for Fibre Channel capability.
S5000
Syntax
show fc switch
Parameters None
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show interfaces fibrechannel command to display information on
the Fibre Channel capability of a switch.
The following table describes the show fc switch output shown in the following
example.
Switch Mode Fibre Channel mode of operation of an S5000 switch.
Default: NPG (configured as an NPIV proxy gateway).
Switch WWN Factory-assigned worldwide node (WWN) name of the
S5000. The S5000 WWN name is not user-configurable.
Example
Dell# show fc switch
Switch Mode : NPG
Switch WWN : 10:00:5c:f9:dd:ef:10:c0
Dell#
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel
interface.
968
NPIV Proxy Gateway