Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
S5000
Syntax
show ipv6 neighbors [ipv6-address] [interface type slot/port]
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface type
slot/port
Enter the keyword interface followed by the interface
type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell#show ipv6 neighbors
IPv6 Address Expires(min) HardwareAddress State Interface/VLAN/
950
Neighbor Discovery Protocol (NDP)