Reference Guide

Defaults 400
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This features allows you to limit the number of multicast entries on the system.
This number is the sum total of all the multicast entries on all stack-units in the
system. For each stack-unit, the multicast module only installs the maximum
possible number of entries, depending on the configured CAM profile.
Use the IN-L3-McastFib CAM partition to store multicast routes. It is a separate
hardware limit that exists per port-pipe. Any software-configured limit might be
superseded by this hardware space limitation. The opposite is also true, the CAM
partition might not be exhausted at the time the system-wide route limit set by the
ip multicast-limit command is reached.
Related
Commands
show ip igmp groups – shows the IGMP groups.
Multicast
945