Reference Guide

Usage
Information
After you enable multicast, you can enable IGMP and PIM on an interface. In
INTERFACE mode, enter the ip pim sparse-mode command to enable IGMP
and PIM on the interface.
Related
Commands
ip pim sparse-mode – enables IGMP and PIM on an interface.
show ip mroute
View the multicast routing table.
S5000
Syntax
show ip mroute [static | group-address [source-address] |
active [rate] | summary]
Parameters
static (OPTIONAL) Enter the keyword static to view static
multicast routes.
group-address
[source-
address]
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group.
Enter the source-address to view routes with that group-
address and source-address.
active [rate] (OPTIONAL) Enter the keyword active to view only active
multicast routes. Enter a rate to view active routes over the
specified rate. The range is 0 to 10000000.
summary (OPTIONAL) Enter the keyword summary to view routes in a
tabular format.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
(Static)
Dell#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change:
00:00:23
Example
(Snooping)
Dell#show ip mroute snooping
IPv4 Multicast Snooping Table
(*, 224.0.0.0), uptime 17:46:23
Incoming vlan: Vlan 2
942
Multicast