Reference Guide

ip msdp cache-rejected-sa
Enable a MSDP cache for the rejected source-active entries.
S5000
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command followed by the ip msdp cache-
rejected-sa {
number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range
is 0 to 32766.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show ip msdp cache-rejected-sa – displays the rejected SAs in the SA cache.
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S5000
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address} list name command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Defaults Not configured.
Command
Modes
CONFIGURATION
916
Multicast Source Discovery Protocol (MSDP)