Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
S5000
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Disabled.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
Version 9.0(1.3) Introduced on the S5000.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
S5000
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command
Modes
INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the
no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
904
Link Layer Discovery Protocol (LLDP)