Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
mode
Set LLDP to receive or transmit.
S5000
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
show lldp neighbors – displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
S5000
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is 2 to 10.
Defaults 4 x hello
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Link Layer Discovery Protocol (LLDP)
903