Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
disable
Enable or disable LLDP.
S5000
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
S5000
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is 5 to 180 seconds. The default is
30 seconds.
Defaults 30 seconds
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
902
Link Layer Discovery Protocol (LLDP)