Reference Guide

debug lldp interface
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other information
about incoming and outgoing packets.
S5000
Syntax
debug lldp interface {interface type slot/port | all}{events |
packet {brief | detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface |
all}{events} {packet {brief | detail} {tx | rx | both}}
command.
Parameters
interface type
slot/port
Enter the interface keyword followed by interface type
and slot/port information. Valid slot numbers are 0-11. The
valid port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
all (OPTIONAL) Enter the keyword all to display information
on all interfaces.
events (OPTIONAL) Enter the keyword events to display major
events such as timer events.
packet (OPTIONAL) Enter the keyword packet to display
information regarding packets coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet
information.
detail (OPTIONAL) Enter the keyword detail to display detailed
packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit only
packet information.
rx (OPTIONAL) Enter the keyword rx to display receive only
packet information.
both (OPTIONAL) Enter the keyword both to display both receive
and transmit packet information.
Defaults none
Command
Modes
EXEC Privilege
Link Layer Discovery Protocol (LLDP)
901