Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When this command is configured, the VLAN is operationally UP if any of the
interfaces specified in the track ip command are operationally UP, and the VLAN
is operationally DOWN if none of the tracking interfaces are operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state
depends on all the members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the
track ip command configuration.
Related
Commands
interface vlan – configures a VLAN.
tagged – specifies which interfaces in a VLAN are tagged.
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
S5000
Syntax
untagged interface-type slot/port
To remove an untagged interface from a VLAN, use the no untagged
interface-type slot/port command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
888
Layer 2