Reference Guide

Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you use the no tagged command, the interface is automatically placed in
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, you must remove it from
all VLANs to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
Related
Commands
interface vlan – configures a VLAN.
untagged – specifies which interfaces in a VLAN are untagged.
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
S5000
Syntax
track ip interface-type slot/port
To remove the tracking feature from the VLAN, use the no track ip
interface-type slot/port command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
Defaults Not configured.
Command
Modes
INTERFACE VLAN
Layer 2
887