Reference Guide

show mac learning-limit
Display MAC address learning limits set for various interfaces.
S5000
Syntax
show mac learning-limit [violate-action] [detail] [interface
type slot/port ]
Parameters
violate-action (OPTIONALY) Enter the keywords violate-action to
display the MAC learning limit violation status.
detail (OPTIONAL) Enter the keyword detail to display the MAC
learning limit in detail.
interface type
slot/port
(OPTIONAL) Enter the keyword interface followed by
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell#show mac learning-limit interface ten 1/0
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/0 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and
use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,
ACLs and SNMP are not supported on a VLAN.
880
Layer 2