Reference Guide

Usage
Information
The following describes the show mac-address-table command shown in the
Example below.
Column
Heading
Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Interface Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet followed by a slot/port.
• te — 10-Gigabit Ethernet followed by a slot/port.
• fo — 40-Gigabit Ethernet followed by a slot/port.
• po — Port Channel followed by a number. The range is 1
to 255.
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
Example
Dell#show mac-address-table
VlanId Mac Address Type Interface State
999 00:00:00:00:00:19 Sticky Te 0/1 Active
999 00:00:00:00:00:29 Dynamic Te 0/2 Active
Dell#
Usage
Information
The following describes the show mac-address-table count command shown
in the Example below.
Line beginning
with
Description
MAC Entries... Displays the number of MAC entries learnt per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses used by the switch.
Example
(Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Layer 2
877