Reference Guide

Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses learned dynamically by the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those
MAC address specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
address mac-
address
(OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
interface type
slot/port
(OPTIONAL) Enter the keyword interface followed by the
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface
followed by the interface type, slot and port information, as
above, you can enter the interface type, followed by just a
slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN
id number to display the MAC address assigned to the VLAN.
The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, followed optionally,
by an interface or VLAN id number, to display total or
interface-specific static addresses, dynamic addresses, and
MAC addresses in use.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
876
Layer 2