Reference Guide

dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses learned dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those
MAC address specifically configured on the switch.
interface type
slot/port
(OPTIONAL) Enter the keyword interface followed by the
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN
ID to display the MAC address assigned to the VLAN. The
range is 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Example
Dell#show cam mac stack-unit 0 port-set 0
VlanId Mac Address Region Interface
0 5c:f9:dd:ee:ff:c2 LOCAL_DA 00001
0 ff:ff:ff:ff:ff:ff STATIC 00001
0 00:10:18:ff:ff:ff STATIC N/A
Dell#
Command
History
Version 9.0(1.3) Introduced on the S5000.
show mac-address-table
Display the MAC address table.
S5000
Syntax
show mac-address-table [dynamic | static] [address mac-address
| interface type slot/port | vlan vlan-id] [count [vlan vlan-
id ]]]
Layer 2
875