Reference Guide

mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address
changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a
given interval.
S5000
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold
number
Enter the keyword threshold followed by the number of
times MAC addresses in VLANs can change before an SNMP
trap is sent. The range is 1 to 10.
interval
seconds
Enter the keyword interval followed by the number of
seconds. The range is 5 to 60.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
For information about the specific trap sent and the corresponding Syslog, refer to
the SNMP Traps chapter.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
S5000
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the
Layer 2 chapter in the Dell Networking OS Configuration Guide.
870
Layer 2