Reference Guide

Defaults off
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
LACP Modes
active An interface is in an active negotiating state in this mode.
LACP runs on any link configured in the active state and also
automatically initiates negotiation with other ports by
initiating LACP packets.
passive An interface is not in an active negotiating state in this mode.
LACP runs on any link configured in the passive state. Ports
in a passive state respond to negotiation requests from other
ports that are in active states. Ports in a passive state respond
to LACP packets
off An interface can not be part of a dynamic port channel in off
mode. LACP does not run on a port configured in off mode.
port-channel-protocol lacp
Enable LACP on any LAN port.
S5000
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show lacp – displays the LACP information.
show interfaces port-channel – displays information on configured Port Channel
groups.
Link Aggregation Control Protocol (LACP)
863