Reference Guide

lacp system-priority
Configure the LACP system priority.
S5000
Syntax
lacp system-priority priority-value
Parameters
priority-value Enter the port-priority value. The higher the value number,
the lower the priority. The range is 1 to 65535. The default is
32768.
Defaults 32768
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
port-channel mode
Configure the LACP port channel mode.
S5000
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords port-channel followed by a number.
The range is 1 to 128.
active Enter the keyword active to set the mode to the active
state.
NOTE: LACP modes are defined in Usage Information
below.
passive Enter the keyword passive to set the mode to the passive
state.
NOTE: LACP modes are defined in Usage Information
below.
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information
below.
862
Link Aggregation Control Protocol (LACP)