Reference Guide

lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
S5000
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command
Modes
INTERFACE (conf-if-po-number)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
Related
Commands
show lacp – displays the lacp configuration.
lacp port-priority
Configure the port priority to influence which ports will be put in standby mode when there is a hardware
limitation that prevents all compatible ports from aggregating.
S5000
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-
value command.
Parameters
priority-value Enter the port-priority value. The higher the value number,
the lower the priority. The range is 1 to 65535. The default is
32768.
Defaults 32768
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Link Aggregation Control Protocol (LACP)
861