Reference Guide

debug lacp
Debug LACP (configuration, events, etc.)
S5000
Syntax
debug lacp [config | events | pdu [interface-type slot/port][in
| out]]
To disable LACP debugging, use the no debug lacp [config | events |
pdu [interface-type slot/port][in | out]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP
event information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information. Optionally, enter an
in or
out parameter to:
• Receive enter in
• Transmit enter out
interface-type
slot/port
(OPTIONAL) Enter one of the following keywords followed
by slot/port or number information. Valid slot numbers are
0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
860
Link Aggregation Control Protocol (LACP)