Reference Guide

show isis protocol
Display IS-IS routing information.
S5000
Syntax
show isis protocol
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
The bold section below identifies that Multi-Topology IS-IS is enabled.
Dell#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
TenGigabitEthernet 1/0 - IP - IPv6
TenGigabitEthernet 1/1 - IP - IPv6
TenGigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
Dell#
show isis traffic
This command allows you to display IS-IS traffic interface information.
S5000
Syntax
show isis traffic [interface-type slot/port]
Parameters
interface-type
slot/port
(OPTIONAL) Enter one of the following keywords followed
by slot/port or number information. Valid slot numbers are
0-11. The valid port numbers for each interface type are
listed below.
Intermediate System to Intermediate System (IS-IS)
855