Reference Guide

• is-type – assigns a type for a given area.
set-overload-bit
Configure the router to set the overload bit in its non-pseudonode LSPs. This prevents other routers from
using it as an intermediate hop in their shortest path first (SPF) calculations.
S5000
Syntax
set-overload-bit
To return to the default values, use the no set-overload-bit command.
Defaults Not set.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Set the overload bit when a router experiences problems, such as a memory
shortage due to an incomplete link state database which can result in an
incomplete or inaccurate routing table. If you set the overload bit in its LSPs, other
routers ignore the unreliable router in their SPF calculations until the router has
recovered.
show config
Display the changes you made to the IS-IS configuration. Default values are not shown.
S5000
Syntax
show config
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
(Router-Isis)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
Dell(conf-router_isis)#show config
!
router isis
Intermediate System to Intermediate System (IS-IS)
847