Reference Guide

isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
S5000
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
isis password
Configure an authentication password for an interface.
S5000
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 |
level-2] command.
Parameters
encryption-
type
(OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the
password using MD5.
password Assign the interface authentication password.
level-1 (OPTIONAL) Independently configures the authentication
password for Level 1. The router acts as a station router for
Level 1 routing. This is the default.
level-2 (OPTIONAL) Independently configures the authentication
password for Level 2. The router acts as an area router for
Level 2 routing.
Defaults No default password. level-1 (if not otherwise specified).
Command
Modes
INTERFACE
832
Intermediate System to Intermediate System (IS-IS)