Reference Guide

upgrade boot (standalone unit)
Upgrade the bootflash or bootselector image on a standalone S5000 switch.
S5000
Syntax
upgrade boot {bootflash-image| bootselector-image} stack-unit
stack-unit—id {booted: | flash://file-path | ftp://file-path |
tftp://file-path | usbflash://file-path}
Parameters
boot Enter the keyword boot to change the boot image.
bootflash-
image
Upgrade the boot image in the bootflash partition.
bootselector-
image
Upgrade the boot image in the bootselector partition. You
are prompted to enter the password.
stack-unit
stack-unit-id
Enter the keyword stack-unit followed by the stack unit
ID of the switch. Valid values are from 0 to 11.
booted: Upgrade using the boot image with which the S5000 booted
up.
flash: After the keyword flash:, enter the location of the source
file in the internal flash in the format:
flash://filepath or press Enter to launch a prompt
sequence.
ftp: After the keyword ftp:, enter the location of the source file
in the format:
//userid:password@host-ip/file-path or press Enter
to launch a prompt sequence.
tftp: After the keyword tftp:, enter the location of the source
file in the format:
//host-path/file-path or press Enter to launch a
prompt sequence.
usbflash: After the keyword usbflash:, enter the location of the
source file in the external flash in the format:
usbflash://filepath or press Enter to launch a prompt
sequence.
file-path Enter the path and filename to be used to upgrade the boot
image.
Defaults None
Command
Modes
EXEC Privilege
78
File Management