Reference Guide

local-distance Enter a number to assign to routes learned from networks
listed in the network command. The range is 1 to 255. The
default is 200.
Defaults
• external-distance = 20
• internal-distance = 200
• local-distance = 200
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
CAUTION: Dell Networking recommends that you do not change the
administrative distance of internal routes. Changing the administrative
distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your
confidence in that route is low. Routes assigned an administrative distance of 255
are not installed in the routing table.
Routes from confederations are treated as internal BGP routes.
neighbor activate
Allows you to enable a specified neighbor/peer group for the current address and subsequent address
family identifier (AFI/SAFI).
S5000
Syntax
neighbor [ipv6-address | peer-group-name] activate
To disable, use the no neighbor [ipv6-address | peer-group-name]
activate command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Identify a peer group by name.
activate Enter the keyword activate to enable the identified
neighbor or peer group in the new AFI/SAFI.
Defaults Disabled.
776
IPv6 Border Gateway Protocol (IPv6 BGP)