Reference Guide

Parameters
half-life (OPTIONAL) Enter the number of minutes after which the
Penalty is decreased. After the router assigns a Penalty of
1024 to a route, the Penalty is decreased by half, after the
half-life period expires. The range is 1 to 45. The default is 15
minutes.
reuse (OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is 1 to
20000. The default is 750.
suppress (OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is 1
to 20000. The default is 2000.
max-suppress-
time
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is 1 to 255. The default is 60 minutes.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of a configured route map. Only match commands in
the configured route map are supported.
Defaults Disabled.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you enter bgp dampening, the default values for half-life, reuse,
suppress, and max-suppress-time are applied. The parameters are position-
dependent; therefore, if you configure one parameter, you must configure the
parameters in the order they appear in the command.
Related
Commands
show ip bgp ipv6 unicast dampened-paths – views the BGP paths.
clear ip bgp ipv6 unicast
Reset MBGP sessions.
S5000
Syntax
clear ip bgp ipv6 unicast * ipv6-address prefix-length
[dampening | flap-statistics] peer-group]
IPv6 Border Gateway Protocol (IPv6 BGP)
771