Reference Guide

redistribute ospf
Redistribute OSPFv3 routes into BGP.
S5000
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to
65535.
match external
{1 | 2}
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enter the redistribute ospf process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes.
IPv6 Border Gateway Protocol (IPv6 BGP)
751