Reference Guide

Related
Commands
neighbor default-originate – injects the default route.
redistribute isis
Redistribute IS-IS routes into BGP.
S5000
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric
metric-value | metric-type {external | internal}] [route-map
map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 |
level-1-2 |
level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6
information.
metric-type (OPTIONAL) The external link type associated with the
default route advertised into a routing domain. You must
specify one of the following:
• external
• internal (default)
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.0(1.3) Introduced on the S5000.
750
IPv6 Border Gateway Protocol (IPv6 BGP)